WIP Beta released ETK I-Series Engine Swaps 0.8

CreasingCurve submitted a new resource:

ETK I-Series Engine Swaps - Adds the ETK I-Series engines, turbos and gearbox to several other cars

Read more about this resource...

 

Really nice that someone is making mods like this available. I just keep mine for personal use. Keep up the swaps! Maybe add a little bit of everything etk into miramar or gm into moonhawk 80's pessima engine in a covet? All really nice swaps good work man

 

The covet i have something in mind for but will be a lot more serious than just an engine swap same goes for the h series which i jave special plans for.
In the next update when i get time. I will actually move the jbeam of the engine so that it fits in the engine bay so that weight distribution is more realistic instead of just moving the mesh. Also the moonhawk will eventually get the ETK I I6 and inhave put the 200bx engine in the miramar but i will not release just 1 engine swap in a pack it will be in atleast 3 different vehicles and will include custom configs and info.jsons so that i dont clutter up the forums like those annoying single config packs that are everywhere.

 

Can you please add it to the Burnside too?

 

I will try to when i get time. Moonhawk is planned aswell.

 

New update is awaiting approval.

 

CreasingCurve updated ETK I-Series Engine Swaps with a new update entry:

Your wish is my command. ETK I6 is finally in the Moonhawk and Burnside

Read the rest of this update entry...

 

What about putting the ETK i6 engine in the Gavril H-Series (the van)? That would be fun to play with, and cool to look at in the engine bay.


200BX aswell?

 

I love obscure engine swaps. As fun as it is to overpower a car from a swap, that can be as fun as underpowering - like watching an NA i6 trying to pull in the H series ambulance.

 

Old mod that I've had for a while, since the ETK I-Series came out, and its all wheel drive

 

In the next update there will be 2 more cars with the I6. 1 car is almost done except for a mesh issue where the airbox of the N/A engine clips through the hood and the intercooler which clips through the front of the car. Other one needs mesh relocation and jbeam to match position of the mesh. Both need a config, info.json and thumbnail but majority of it is done. Update should be out in just over 2 weeks. It mainly depends on when the update gets released as I will have to rework the drivetrain which is the main component of this mod.

 

this mod doesnt seem to install by itself, I just dump the contents on the folders?

 

Wat. It wont work at the moment anyway because the powertrain code broke all mods like this. I am working on it though, just need to reupdate all the content in the mod and add new cars so it is better than it was before.

 

Great, thanks

 

CreasingCurve updated ETK I-Series Engine Swaps with a new update entry:

Just getting it working again.

Read the rest of this update entry...

 

They all sound like the old beamng engine sounds did, not like the new etk sounds

 

Bump
also, this is most likely outdated