Development Screens (Each post contains a picture OR contributing post)

how do I resolve this?

 

You'll need to reposition the rear wheels.

 

how? jbeam need to edit the file?

 

Look in the suspension_R and mess around with the wheel's Y and Z.

 

200+ MPH fail on unknown setup

 

First, the central node of the wheel must be positioned correctly.

Then, you need to position the wheel mesh in the flexbodies section to match your pressureWheel.

 

where?

 

Is it sitting in an older jbeam?

 

Nodes seem to be positioned correctly.

You just need to move the wheel mesh to match the structure.

Check this out for instructions.

 

Oil Cooler done

 

a sneak peek...

 

flat nose T-Series based truck?

 

Looking good...

In game unibody picture (ignore the badly placed engine)

guess the jbeam that I am modifying to work for this vehicle

 

Wheel Pack awaiting approval

It will add 29 wheel designs and over 350 wheels (that's all the wheel designs with different sizes).

After this update I have a few wheel models, which I got from @Razer-11, that I will add.

 

Im guessing the covet. or the sunburst.

 

waiting for approval

 

Try making a JDM D15 and rename it Ibushi P15 or something like that. (there was the original ibishu dove that was a jdm d15 but it was not RHD)

 

Dashboard/Center Console render

The mesh is a widened ETK 800 Dashboard/Center Console that I am rebuilding the UV map for my minivan mod

 

i could give you my pessima minivan if you want to try and figure out sliding doors. i may be able to explain how it works, tho im not too good at explaining things.

EDIT
to clarify. i mean to copy. the doors work fine. i have them so they get pushed out, then go back.

 

You should be able to use hydros and slidenodes to setup sliding doors if I'm correct?

OT: Fairly rubbish low poly twin car race trailer I've been working on, nothing terribly fantastic whatsoever but that's about all you can say about my mods
Planning on more car-related trailers as well, probably a single car race trailer and a gooseneck race trailer. Definitely a standard non-enclosed car trailer as well, towing cars around with the small trailer doesn't work particularly well hence this.


--- Post updated ---
Something I was working on, a dragway (pretty close to a quarter mile, give or take a metre or so) with some other interesting stuff. I plan to add a gymkhana thingy with some abandoned factory stuff as well, maybe some ramps for stunting as well on a closed course. That awful mess with the roads going up it will eventually look like a mountain, with nice twisting roads, similar to this picture of Cambewarra Mountain in NSW, Australia: http://www.ozroads.com.au/NSW/RouteNumbering/State Routes/79/12.JPG.
There is a beach on one side and a small town on the same side as the dragway, with a little fuel station. Most of this map is unfinished apart from the dragway itself, which is very close to done. I haven't been working on this for ages as I haven't been very motivated, however I may start work again soon.