Hi there!
Quarantine really had me bored so I decided to revisit my old air suspension mod for the ETK. This time, the car uses actual air suspension based on the bus's kneeling function. I would like to thank @Blijo and @OverPower for their mods as I used them to figure some of the ins and outs of the input_actions and also how to set the suspension up so it wasn't the same consistency as a water bed.
This mod contains Air Struts in the front, Air Spring and Low Shock in the rear, and revised Air Front and Rear Suspension. There is no pre-made configuration.
Anyways, this mod is meant mainly to slam the car, but has many purposes such as supporting heavy loads.
These are the vehicle controls. Y and G reset the front and back of the vehicle to a predetermined middle height, respectively. The Ctrl and Shift variants of those progressively lower and raise the front and back.
KNOWN ISSUES:
To get the correct ride height and suspension stiffness, it required me to essentially pre-load the suspension. This makes a breaking noise as you spawn in which always happens. It only occurs once.
Dismiss Notice
In the upcoming days mod approvals could be slower than normal.
Thank you for your patience.
In the upcoming days mod approvals could be slower than normal.
Thank you for your patience.
ETK 800 Air Suspension Redesign 2.0
Make your ETK 800 scrape on leaves!
Tags:
-
Images
Recent Reviews
-
-
-
Author's Response
-
-
-
-
Author's Response
Possibly. If you'd like, you can use whatever you need from this mod to make it work.
-
-
-
-
Author's Response
I had one in the works at one point, but it is quite difficult to do on the D-series as it needs an entirely new frame, bed, and suspension otherwise it won't go far enough up. So honestly, I doubt it at this point.
-
-
