Beta Covet AWD v0.7

I already wrote a little announcement in the Discussion tab, so here's the short Changelog:

- Added Models for MR Layout Rear part of Drivetrain
- Added 6-Speed Manual Transmission to both Layouts
- Fixed Rear Right Halfshaft Deformation
- Fixed MR Layout front Drivetrain Models

FINALLY!!!

I've finally figured it out (I hope...........)

alr, so here's the changelog:

• Driveshafts no longer are out of place, AND SHOULD EVEN ROTATE AT THE CORRECT RPM!
• The issue from last update with the rear Driveshafts is now fixed, should be better than ever before!
• With the MR Layout, the Node of the Front Differential wasn't properly attached, this is now fixed, too!

well, would be too great if everything worked perfectly:

• MR Layout: Driveshaft...

- Removed Rear Halfshafts for Front Engine Layout as a Part as they're not needed and just did some weird stuff to the Front Halfshafs*
- Maybe (hopefully) fixed the Rear Halfshafts sticking through the trunk floor
- Fixed some stuff with the Mesh of the Rear Differential, deformation should now be WAYYYY better

*basically, I copied the Code from the Front Half Shafts, but somehow forgot to change that, so (un)equipping the Rear Half Shafts actually changed the State of the Front Wheels...

Finally! New Update 0.5 out!

Highlights of Changes/Additions:

• Added Models for various Parts for Front Engine Layout (thanks @barabash)
• Changed Jbeam to make sensible use of the Models (e.g. not show the Front Engine Layout's Rear Diff Models for the Rear Engine Layout's Rear Diff)
• Sadly, the Textures are quite big in File Size, so the new Update is now significantly larger than the last Update (~5.5KB -> ~ 30MB), but I guess Quality comes at some...

Basically, I forgot to remove the halfshaft beams and the transmission nodes for the Rear Engine Front Diff which caused the dangling halfshaft issue.

I've noticed an issue with the Front diffs which has now been resolved, the Rear Engine Front Diff and its Halfshafts should now only work in the drivetrain logic, but they shouldn't have any nodes or beams which could be dangling around.

Unfortunately, this makes it a bit unrealistic as there is now nothing between the front wheels which...

Removed the Flexbody and Beams from the custom front Halfshafts in the MR config because they were just hanging around causing Problems

The original Plan was to make a Model and everything for the Front Differential, but I just don't have the Time and Expertise in Blender to do so, which is why this is coming so late

Just a quick fix for the Hood not opening when a Front Differential is used

now you can spin with your Hood opened!

Everything from the previous versions was made available for the Front-Engine Covet now!

Added
- Open Diffs
- Welded Diffs
- standard LSDs
- locked 4WD transfercase with disconnectable front & rear shaft

fixed defaults, added matching Final Drives
(and made it working at all)