Hey guys, I'm having trouble creating a 4.1L Diesel inline-6 for the D-series I would like it to make 142 HP @ 3500rpm and 250 LB-FT of torque @ 2000rpm Problem is: When I get into the game and open the dynometer with that engine installed, it says that the peak is 384 LB-FT @ 3100rpm and 197 HP @ 4100rpm How could I fix it to make the stats above? Tell me how, heres the jbeam file:
What is your intake file as intake you have written in engine file is not to be found from engine file? If you have a turbo, then it is bit complicated, check links in my signature for tools.
You have set your torque to be 160Nm @ 2000rpm [2000, 160], In game you should have 120Nm or there about for 2000rpm with jbeam file you have attached. You might have different engine that is named same as engine you did attach to your post or your intake might contain something more than it should. With these values you should have correct power and torque, but only if these are values game reads and there are no intake modifications, turbo etc.: [ 2000 , 369.42 ], [ 3000 , 335.14 ], [ 3500 , 326.49 ],
