Object Issues

I made an object in Google SketchUp, I followed a tutorial I had used before (which worked), but the collision triangles are way off. I tried as much as I knew how to do (which isn't a lot), but nothing worked.
Please help!

 

I guess you dont use a seperate colmesh if you use sketchup?
Is the mesh centered on 0,0,0 of the world space in sketchup? If its not, the colmesh can be anywhere else, and also it might have different orientations then i think.

 

looks to me like you built the object in the wrong location of the workspace in sketchup.

Only build within the section where the little person is placed when you start sketchup. Do not build across the red and green lines and don't go below them. Do not try to center the object over the origin (the point where all the lines meet) as this happens. Also make sure to explode all groups as this can cause problems too.

Just select your object and move it to the correct place. Then export it.


If none of these work then it could be that you need to leave the editor for the collision shape to update to its correct position. Though the problem would have been resolved when you next loaded the map so I guess this was not the case.

hope this helps

 

Thanks, I'll make sure that's what I did.

 

Jammin2222 was so nice to create this Tutorial since the last post of you here, maybe it can help you.
http://www.beamng.com/threads/7216-...ollision-meshes-(not-visible-mesh-collisions)