Low GPU usage on WC USA

Hello Everyone,

I get round about 60 fps on WC USA and 120 on Utha.
But on Utha my GPU usage is at 100% and on WC USA only at 60%.
(without Traffic)

Specs:

CPU: R5 5600g
Gpu: RTX 4060
Ram: 32GB 3600mhz

I hope somebody can help.

 

Your Ryzen 5 5600g is the bottleneck in this case. WC USA is a lot more cpu intensive than Utah. Your CPU may not show 100% utilization, but some of your cores will be maxed out. This is because BeamNG doesn't utilize all your CPU scores and that's why your GPU is unable to perform at its best.

The above reason is the most probable cause, under some assumptions:
1. Your RAM is running in dual-channel mode
2. Your Nvidia Drivers are up-to-date

Here are some ways you can improve GPU utilization:
1. Play at a higher resolution (I am guessing you were using 1080p, 1440p would be a nice sweet spot, if possible)
2. Balance GPU/CPU intensive graphics settings in BeamNG
3. Make sure your CPU is not being limited by your OS/any application
4. Try the Vulkan Render