Hydros is breaking my jbeam file

Discussion in 'Content Creation' started by ThreeDTech21, Aug 7, 2015.

  1. ThreeDTech21

    ThreeDTech21
    Expand Collapse

    Joined:
    Sep 27, 2013
    Messages:
    1,616
    Im following the tutorial here: http://wiki.beamng.com/Introduction_to_Vehicle_Creation

    all is working well untill i get to the point where i learn to create Hydros I add the code that is provided but my car will not load after adding that code after the beams section

    here is how it looks in my notepad++

    hydros not working.PNG
     
  2. SixSixSevenSeven

    SixSixSevenSeven
    Expand Collapse

    Joined:
    Sep 13, 2013
    Messages:
    6,958
    Use the debug console in future...
    hydros not working.PNG
     
  3. randomshortguy

    randomshortguy
    Expand Collapse

    Joined:
    Aug 9, 2013
    Messages:
    1,562
    I'm no jbeam wizard but I think you've ended the hydros section twice. Remove one of the closing brackets. Also, the previous section was never ended. So add a closing bracket there too.
     
  4. ThreeDTech21

    ThreeDTech21
    Expand Collapse

    Joined:
    Sep 27, 2013
    Messages:
    1,616

    Thanks all! I was able to get it working, the tutorial assumes that the reader will remember to use a closing bracket before starting a new section. Also i did have two closing brackets, Now I will always remember to do that, Ill use the debug console from now on, cheers :)

    - - - Updated - - -

    New problem, when I add hubwheels the car wont load now. How do i use debug console to post the code?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice