Gear 0 in dct

I was testing random stuff and found out when using dual clutch transmission, if you have some reverse momentum in then go to manual (you got to be in realistic mode) it goes in gear 0. Once you are on gear 0 you cant accelerate at all until you must shift up (goes to 2nd gear), shifting down (don't matter where) dont help because you cant accelerate still. That can be really annoying when stopping from reverse then drive in dct.

 

From there forwards few posts discusses about this issue, as @Diamondback wrote there, it is bit hard to make happen, sometimes it happens. I'm putting link here to have your experience linked to what other bits of info has been gathered:
https://www.beamng.com/threads/0-8-...-thread-read-1-post.33989/page-27#post-534860

 

I guess people finally starts to notice it. Good job fixing, it, I just managed to make a video about it

 

Ahh I didn't noticed its reported on that thread. Thanks. I guess I didn't look through the forums deeply enough.

 

I noticed it back when update 0.8 came out. I noted it but forgot to report it.