Im working on a mod that allows customization to the steering and im stuck. Code: ["$angle1", "range", "", "Alignment", -0.175, -0.100, -0.200, "Turn angle 1", "NOTE THIS VALUE HAS TO BE THE SAME AS TURN ANGLE 2 BUT THIS ONE IS NEGATIVE"] ["$angle2", "range", "", "Alignment", 0.175, 0.100, 0.200, "Turn angle 2", "NOTE THIS VALUE HAS TO BE THE SAME AS TURN ANGLE 1"] ^ Those are my variables and i want to combine the two to one the reason being that it is simple and easier to use Code: "hydros": [ ["id1:","id2:"], {"beamPrecompression":1.0, "beamType":"|NORMAL", "beamLongBound":1, "beamShortBound":1}, {"beamSpring":5501000,"beamDamp":50,"beamDeform":"FLT_MAX","beamStrength":300000}, ["fh6r","fx5l",{"factor":"$angle2","steeringWheelLock":510,"inRate":1.25,"outRate":1.25}], ["fh6l","fx5r",{"factor":"$angle1","steeringWheelLock":510,"inRate":1.25,"outRate":1.25}], {"beamPrecompression":1.0, "beamType":"|NORMAL", "beamLongBound":1, "beamShortBound":1}, Thats what the variables are going to they are editing how far the wheels turn at full lock I need to have it where they change one value in the tuning section to a value lets say 2 When they put two it changes the value inside $angle1 to a negative ( EX : "-$angle1" when i do Code: ["fh6l","fx5r",{"factor":"-$angle1","steeringWheelLock":510,"inRate":1.25,"outRate":1.25}], It does not like the code and will not load the vehicle and when i do Code: ["fh6l","fx5r",{"factor":-"$angle1","steeringWheelLock":510,"inRate":1.25,"outRate":1.25}], it also does not load the vehicle. (The difference is where the negative is placed) If anyone has a solution that would be great.
Bump cuz i wanna make this work too. ive been trying to make an adjustable drift steering but im running into the same issues.. --- Post updated --- Plot twist. turns out i just found out how to do it lmao. Code: ["$steer_angle_node", "range", "+m", "Wheel Alignment", 0.24, 0.2, 0.9, "Node Position", "Steering node adjustments on the x axis", {"stepDis":0.001,"subCategory":"Front"}] ["fh6r", "$=-$steer_angle_node", -1.09, 0.177], ["fh6l", "$steer_angle_node", -1.09, 0.177], you need to add $=- in front of the one you want a negative value.